How do I connect to a 831-INT-ET with wired Ethernet?
Required equipment:
- Model 831 running firmware V2.110 or later
- Model 831-INT-ET Docking station with firmware V2.1 or later
- Wired Router with at least 2 ports and 2 CAT5 cables
1. In order to avoid conflict with existing other networks, please ensure the wireless LAN on your PC is DISABLED.
2. Boot up the router connecting your PC using a CAT5E cable using port 1 of the router. Check with the standard tools to find the IP address. In the display below you will recognize:
a) Default Gateway: 192.168.1.1
b) IP Address (of your PC): 192.168.1.2

3. Prepare the 831-INT-ET with 831
a) Place the 831 in the 831-INT-ET cradle and secure with the screw.
b) Connect the 831 USB cable to the 831-INT-ET “USB B” port.
c) Connect the LAN cable from the 831-INT-ET “Ethernet” port to port 2 on the router.
d) Power up the 831-INT-ET
e) Wait about 3 minutes to be sure that the 831-INT-ET is booted, has started a communication with the router and with the 831.
4. Start SLM-Utility-G3 V2.110 or later
a) Go to “Connection” » Remote » Internet and enter the next available IP address (in this case 192.168.1.3)

b) Click “Connect”
The SLM Uitlity-G3 program will quickly locate the 831 because of the shortness of the cables.
c) You will see a screen like this:

d) You are connected to the Model 831 via the Model 831-INT-ET Docking Station and the router.
Connection Photo

The AC adapters are not shown.
The BLUE CAT5 cable goes to the PC (PC not shown).
The USB cable between 831 and 831-INT-ET must be installed for before the 831-INT-ET system boots
|
|
|
|
|
|
|
|